



The regulator BlueSolar PWM LCD & USB 12/24V 5A implements the PWM controller, simple, lightweight and low cost. It features a liquid crystal display for monitoring and configuration. The fast adjustment of the settings and the timer is performed through the seven segments and the two-digit display.
The regulator charges the batteries in three stages are not programmable: bulk, absorption and float. Algorithms are pre-programmed for the charging of batteries AGM, GEL, flooded and Lithium Iron (with BMS internal).
Features two USB ports 5 Volts and 2A of peak current (both outputs together).
It has internal temperature sensor to prevent overheating. The regulator is protected against over-current, short circuit and polarity reverse of the panels or of the battery, to avoid accidents and damaged equipment.
| Voltage of the battery | 12/24V (automatic Detection) |
| Rated charge current | 5A |
| Automatic load disconnect | Yes |
| Maximum solar voltage | 28V/55V |
| Self-consumption | < 10 mA |
| Output load | Manual Control + disconnection by low voltage |
| Protection | Reversal of the battery polarity (fuse), output Short circuit, Overtemperature |
| Overload protection | Disconnection after 60 s in case of reaching the 130% load, timeout after 5 s in case of reaching the 160% load, immediate Disconnection in case of short circuit |
| Grounding | Positive common |
| Working temperature range | -35 to +60°C (full load) |
| Humidity (without condensation) | Max. 95% |
| Weight | 0.15 Kg |
| Measures | 96 x 169 x 36 mm |
Browse the Victron Energy range, compare other solar charge controllers and pair the unit with compatible solar panels and solar batteries. Before ordering, check system voltage, maximum controller current and the permitted PV array power.
Data sheet
You might also like
Victron SmartShunt 1000A / 50mV Battery Monitor Built-in Bluetooth