Published dimensions: 151 × 98 × 95 mm. Sealed INNPO 12V 14Ah AGM VRLA battery for compatible electric bicycles, scooters and backup equipment. Positive terminal on the left; check connectors, total height and charger before ordering. It may also replace a compatible 12V 12Ah AGM battery in UPS and other equipment: 2Ah more with the same published dimensions.
The INNPO INPD12-14Ah is a sealed 12V 14Ah AGM VRLA battery. It can replace a module in a system requiring the same voltage, capacity and technology, including some light electric vehicles and backup equipment. Capacity alone does not establish compatibility.
If your UPS, alarm, emergency lighting or backup system uses a 12V 12Ah AGM battery, this 14Ah INNPO model is a higher-capacity option: 2Ah more nominal capacity, while both listings state 151 × 98 × 95 mm. It may provide longer backup under suitable conditions, but no specific runtime can be guaranteed.
Before replacing it, confirm that the equipment accepts 14Ah, total height and terminals fit, polarity matches and the charger supports AGM. If a UPS uses two or more batteries, do not mix capacities or old and new units without following the equipment manufacturer’s instructions.
Possible uses include electric bicycles and scooters built with 12V AGM blocks, mobility equipment and auxiliary power. We cannot confirm fit for a particular vehicle without its original battery details. Browse other INNPO batteries.
Many light electric vehicles, including bicycles, scooters and mobility aids, use several modules or a lithium battery pack. One 12V block is not a complete 24V, 36V or 48V pack. Check the number of batteries, their wiring, the required chemistry and the charger. Do not replace lithium with AGM without technical validation.
Compare the old battery label, available space, terminal type and positive-terminal position. The published dimensions are 151 × 98 × 95 mm; verify total height before ordering. Compare 12V lead-acid batteries and electric bicycle batteries.
| Check | What to verify |
|---|---|
| Pack voltage | Number and wiring of 12V modules |
| Technology and charger | AGM and suitable charging profile |
| Dimensions and terminals | Space, total height and connector type |
AGM, GEL and LiFePO4 need not share a charging profile even where voltage and casing dimensions appear similar. Follow the equipment maker’s specified technology.
Use an AGM-compatible charger and observe polarity. Avoid leaving the battery deeply discharged; store it charged in a dry, ventilated location. If the system uses several blocks, ask the vehicle maker before mixing old and new units.
These details describe one 12V module, not the voltage of a complete battery pack. Check the original specifications before installation.
| Specification | Value |
|---|---|
| Reference | INPD12-14Ah |
| Technology | AGM VRLA |
| Nominal voltage | 12V |
| Nominal capacity | 14Ah |
| Published dimensions | 151 × 98 × 95 mm |
| Positive terminal | Left |
Does it fit every electric vehicle? No, only systems using compatible 12V AGM modules. Is it a direct replacement for 12V 14Ah lithium? Not necessarily: the charger and electronics may differ.
Data sheet
Everything was OK
You might also like
INNPO 12.8V 14.5Ah LiFePO4 Battery
Published dimensions: 151 × 98 × 95 mm. Sealed INNPO 12V 14Ah AGM VRLA battery for compatible electric bicycles, scooters and backup equipment. Positive terminal on the left; check connectors, total height and charger before ordering. It may also replace a compatible 12V 12Ah AGM battery in UPS and other equipment: 2Ah more with the same published dimensions.
